AS 532 U2 Cougar
[Page 7]
Cougar model in 1/32 scale
Matchbox / Revell Puma Helicopter Conversion
Cougar Page
1
Cougar Page
2
Cougar Page
3
Cougar Page
4
Cougar Page
5
Cougar Page
6
The undercarriage of the Cougar is very different from the Puma gear. On the model it was made from plastic rod and strong paperclip metal wire. Wheels came from the spare parts box. The main wheels have another shape and diameter than those of the (kit's) Puma.
Engine area: final details
Engine area got various details made from rod and sprue.
Two different rear engine fairings
were made, they are interchangeable to show the model in two configurations.
The JDD fairings are also seen here,
installed
. 
Interior with water tank and small seats. Straps were made from white wire.
The water tank got its 4 large pipes to dump the water. Made from thick
rod from sprue as found in many kits with a hole drilled in. In real life,
these pipes are fitted AFTER the tank is forklifted in the cabin. And the
same applies for the model...
Final Finishing
Installing all various parts and sub-assembly
pieces was next. This imposed no problems.
The final finishing details were:
- adding small antennas
- adding wire antenna on top of vertical
tail
- adding the mirrors and so on the
cockpit glazing; these were made with thin rod.
Back to 1/32 models....
(c) Copyright "designer"/ All rights reserved/ Amsterdam The Netherlands.